Here you can see the longer fasteners are for the rubber feet. All you do is slide the fastener through the foot and leg and then thread in the screw.
 

I left the fastener just a little short so the screw will tighten against the metal in place of the rubber.
 

Here you can see the shorter ones are for the pointed feet. And the principle goes for these, the fasteners are left a little short.
 

Note that I changed screws in place of the smaller heads on the first ones. These worked better but I liked the look of the others.
 

Using a hex key and screwdriver tightens these in seconds.
 

And switching between them is very easy and can be done in the field.
 

This was a quick and easy modification that only took a few hours and was fun to do.

Now I'm ready to do some shooting in different kinds of conditions.
 

1   2