Art Project 4                                                7-2022

It's Finished   Here it is all finished.

I sprayed some matt clear over the whole project.

Here you can the two lug nuts that I cut on my lathe here.

There are eight, 10-32 bolts that are welded to those guide plates.

The front consists of some 7/16" bolts welded together that fasten to the lock-nuts.

Here you can see what those five small screws look like and where they are used.

A view from within.

It sits nice and low.

The setscrews are used to hold the gears on that axle and allows them to spin.

Those roller rockers sure did perform good when they were in my car.

That round gold part is a titanium valve spring retainer being held on with lock nuts allowing those bearings to spin.

Here you can see I cut some of the threads off that should bolt so they sit flush with the wing-nut.

This is the underside of the project.

I had fun making this and might make more in the near future.

1    2    3    4